« PREV. PAGE NEXT PAGE »


ZEX 2010 Chevy Camaro V8 Nitrous System

This  innovative  nitrous  system’s  Active  Fuel  Control  adjusts  fuel  delivery  with  changes  in nitrous  bottle  pressure  so  that  your  engine  never  runs  too  rich  or  too  lean  while  spraying.  In addition, the system also offers an electronic TPS switch for reliable system activation at wide-open throttle; perfect for the Camaro’s  throttle-by-wire  system. These patented, innovative features make ZEX nitrous systems unlike any other kits on the market.

The easy-to-install ZEX system is available in both the classic purple or the new Blackout series with its black powder coated bottle and all necessary accessories for a simple, two hour installation. The ZEX 2010 Chevy Camaro V8 Nitrous Kit is simply the easiest way to add serious performance to this new vehicle, while at the same time ensuring engine safety. With all the extra torque and horsepower, it’s not uncommon to see over one second quicker e.t.s in the quarter mile.

For more information, head to zex.com.

KATECH PERFORMANCE DEBUTS FRONT SPLITTER WITH UNDERTRAY, BRAKE DUCT KIT

The new Katech Carbon Fiber Front Splitter, Undertray and Brake Duct Kit (part # KAT-A4979) includes the Katech Carbon Fiber Front Splitter combined with a full-length undertray extending to the radiator.  New carbon fiber brake ducts draw air from the front of the splitter and direct it to the braking system. Designed to fit the C6 Corvette Z06, ZR1 or Grand Sport models, the kit is easy to install due to its four-piece design.  No drilling is required and all stainless steel hardware is included. 

Katech wind tunnel testing shows that, when installed, the kit eliminates high speed front end lift found on the stock C6 Z06 and brings it into the negative (downforce) that racers desire.  When used in combination with Katech side skirts and rear spoiler, aerodynamic balance is achieved to near perfection.  Rather than trying to pull air from the bottom of the vehicle like a stock car set-up, Katech engineered the kit's brake cooler inlet as a direct path from the front of the vehicle.  Again, wind tunnel smoke testing illustrates this design provides an effective way of getting air to the brake system without causing front end lift. 

Constructed of 100 percent pure carbon fiber and made in the U.S.A., the Katech Carbon Fiber Front Splitter and Brake Duct Kit comes with a stainless steel hardware kit and retails for $1,774.99.  Katech also sells a splitter without undertray and brake ducts for $575; A fiberglass version is available for $399.99.  For more information, call 866.KATECH1 or visit www.katechengines.com.

ATI Introduces Super Dampers for the 2010 V6 Camaro

ATI Performance Products, Inc. is proud to introduce its Super Damper line for the 2010 and newer V6 Camaro. The 2010+  6-groove pulleys are available with 25% (918638) and 10% (918637) under drive or an OEM replacement size (918636). The Super Damper has a thicker wall rear hub to prevent failures from added HP, and will include a new long life front seal and seal installation tool. These dampers also include provisions to bolt on supercharger crank pulleys.  This is the same style damper that comes on all Mopar Drag Pak and SMS Challengers as well as Arrington Mfg vehicles! All three dampers come with laser-etched timing marks and exceed SFI 18.1 Safety Certification.

For more information go to www.atiracing.com.

« PREV. PAGE NEXT PAGE »